Fast Download,all pages present,an excellent copy.THis enabled to find the origional part numbers and chase them up. The cartridge is proving difficult to find but at least I know the origional part number.Thanks to all.
Very good manual, in depth and complete. Only criticism is that some of the circuit diagrams are slightly blurry and hard to follow for long periods of time, but this is to be expected. Perfect for any maintenance required. Also contains the wiring diagrams of the control cable for constructing extensions.
Text excerpt from page 34 (click to view)
Note: When replacing/reassembling the infrared LED harness and MX ground wire, ensure that the cable length for the main frame R side as follows; Infrared LED harness: 130 ± 5mm MX ground wire: 65 ± 5mm
3.3.6 (1) Actuator A/B Release the hook on the right hand side on the rear cover B to remove it.
Main frame R
hook
Main frame R
Rear Cover B
Main frame L
Fig. 3.24
(2)
Remove the five idle gears 34, five swing arms and two gears 24 from the main frame R. Idle Gear 34
Swing arm Idle Gear 34 Swing arm
Swing arm
Idle Gear 34 Main frame R Idle Gear 24
Swing arm
Projection mark Main flap shaft Projection mark Fig. 3.25
Note: When reassembling the swing arm onto the main flap shaft, refer to the figure above.
III-15
